ProNature Outdoor Wood Sealer
Add a warming coat of ProNature Outdoor to your exterior wood with this natural, sustainable formulation that contains no harmful ingredients such as formaldehyde or aromatic solvents found in ordinary paint.
ProNature Outdoor – Truly Earth Friendly!
ProNature Outdoor is easy to apply and to maintain and is suitable for any type of wood. ProNature Outdoor works to seal and protect the wood and give it added water resistance, thus saving your outdoor wooden surfaces from water and sun damage.
- Exterior and interior wood sealer
- Suitable for all wood types
- Matte finish
- Water repellent
- UV resistant
- Easy to apply
- Low maintenance
- Natural, sustainable ingredients
- VOC FREE
Clean surface and sand wood to a very fine, smooth finish using grit i.e. 100.
The surface must be dry, clean and dust-free.
Depending on the type of wood and the surface roughness, the colour impression can vary considerably i.e. coarsely sanded wood develops much darker colours.
Coverage: Approximately 20-30 m²/liter/per application
Coverage is much lower when applied to roughly sanded surfaces.
For untreated wood:
Stir material well before application. ProNature Outdoor is applied liberally using a brush or dip application.
Where suitable material can also be sprayed. In order to avoid glossy spots and prolonged drying, it is necessary to remove any excess that has not been absorbed after about 10 min using a lint-free cloth.
Leave to dry for a minimum of 6 hrs.
A light sanding after drying is recommended if necessary. Then apply a second coat of ProNature Outdoor following the above instructions. Allow drying for a minimum of 6 hrs.
Again a very light sanding is recommended if necessary before applying the final coat following the above instructions.
Only surfaces, which are subject to extreme weather conditions, should receive an additional coating after a 24 hr drying period.
For interior use an application of two to three coats is adequate.
Cold weather and high humidity will retard the drying
For previously coated wood:
Remove all previous coatings by means of sanding or suitable paint stripper. Sand to a very fine, smooth finish. Any wood defects like deterioration by fungi or insects must be removed and a pre-treatment with a suitable agent may be required. After pre-treatment follow above instructions for untreated wood.
ProNature Outdoor is ready to use and needs not to be diluted. Depending on the wood type a thinning down of the first coat with about 10 % of ProNature Plant Turpentine is recommended. Clean tools with ProNature Plant Turpentine.
ProNature Outdoor should be applied in regular intervals at least once a year or whenever necessary.
Storage: A minimum of 6 months in unopened containers when stored in a cool and dry place.